Used Cable Granulator Recycling Series

Used Cable Granulator Installation Method

1.How to make Electrostatic Separation Connect To Ground?

The yellow wire access angle iron

Another wire connected to the angle iron

The two wires in the electrostatic separation,one is used to protect the motor and the other is used to protect the machine. They are respectively connected to the holes of the angle iron, and the depth of each hole is at least 1 meter deep.

2.How to adjust the dust fan?

Dust fan adjustment handle as above the green frame

Suction fan blower adjustment

Dust collection equipment can adjust the air volume of the wind suction fan blower 45-50.

electrostatic separator

electrostatic separator

Pictures and videos after installation of electrostatic separation equipment for your reference：

3.How to Install Water Pump Part?

The water pipe above the cooling water tank is connected to the water tank, and the water pipe below is connected to the water pump.

The video of the water pump connected to the crusher for your reference

Put the Pump on the Lifebuoy

Installed water pump

4.How to Install the Metal pipe?

Draw in the fresh air outside

Metal Pipe-fresh Air Inlet

5.How to clean the dust on the air separator sieve?

High-pressure air gun to clean the dust on the air separator sieve.The video is as follows：

6.The functional effect of the waste copper granulator separator blade

 

The gap between the fixed blade and the movable blade of the waste copper granulator separator machine should be as small as possible, and the gap between the fixed blade and the movable blade of our BSGH waste copper granulator separator machine is very small.

As shown in the following video, the fixed and moving blades of our waste copper granulator separator have high accuracy, the gap is small, and the plastic paper can be easily cut off：